QUESTION#01 

MPLS supports both static and dynamic LSP establishment. Which of the following protocols cannot dynamically establish LSPs in MPLS TE scenarios?

A: OSPF

B: IS-IS

C: RSVP-TE

D: BGP

 View answer 

QUESTION#02 

Which of the following statements about SR-MPLS BE and SR-MPLS TE is correct?

A: Both SR-MPLS BE and SR-MPLS TE tunnels can be established based on specified explicit adjacency SIDs.

B: SR-MPLS TE tunnels can be established based on both specified node SIDs and adjacency SIDs.

C: SR-MPLS BE tunnels can be established based on both specified node SIDs and adjacency SIDs.

D: When creating an SR-MPLS BE tunnel, you can specify explicit routers.

 View answer 

QUESTION#03 

An SRv6 Policy can be either statically confiqured on a device,or be delivered to a device after being dynamically generated by the controller.

A: TRUE

B: FALSE

 View answer 

QUESTION#04 

For telemetry data push, data can be transferred between devices and colectors using the TLs protocol.Tls must be conigured for data encryption ifdata is pushed based on gRPC.

A: TRUE

B: FALSE

 View answer 

QUESTION#05 

SR-MPLs uses the MpLs forwarding plane, and therefore requires MpLs to be enabled.Which of the folowing conditions must be met for MPls to be automaticaly enabledon an interface?

A: The SRGB is configured for the IGP process.

B: The static adjacency label of the corresponding interface is configured in the segment routing view.

C: Segment routing is enabled in the system view.

D: Segment routing is enabled for IGP, and IGP is enabled on the interface.

 View answer